1. Make sure the unit is unplugged.
2. Stand the unit on a table and grasp with one hand.
3. With other hand, move the release switch up toward the steam head nozzle.
4. Pull the reservoir out, away from the steamer body.
5. The rubber inlet cover is located on the top of the water reservoir.
6. Open the inlet cover and fill the reservoir with water.
7. Close the inlet cover and return the reservoir to its place, making sure that it snaps in place and is secure.
1. Fill water reservoir with water (see above).
2. Plug the unit into the electrical outlet.
3. The blue READY light will illuminate and begin blinking. Allow 40 seconds for the unit to warm up. The appliance is ready to use when the READY light stops blinking and remains solid.
Note: Before first use or when the unit has not been used for a long period of time, it will be necessary to prime (i.e., fill with water) the internal tank while the steamer prepares to steam. You may hear a small tapping noise during the heat-up process; this is normal.
4. Your steamer has 2 options for steam, regular Steam and Turbo. Use the Steam setting (blue button) for delicate fabrics or freshening lightly wrinkled garments. Use the Turbo setting (red button) for thicker fabrics and heavily wrinkled articles.
5. Pointing the steam jets away from you, and anyone else in the room, press either the blue Steam button or the red Turbo button to release steam. Always have steam facing away from you or anyone in the room.
6. To stop the flow of steam, depress the button(s) that you have turned on, either the red, blue, or both.
7. Unplug the device when it is not in use.
This garment steamer has a built-in creaser on the top of the unit. To use, slide garment under the clip and align edge with the pattern as marked on the creaser. Press the Steam button and steam will issue from the port on the top of the unit. Slide the steamer along the edge of the garment to create a sharp crease.
Note: Steam will continue to emit from the steam slot on the front of the unit during creaser use!
With the garment steamer off and cool, snap the silicone brush attachment over the steam head ensuring it is firmly affixed. At this point the silicone brush can be used or you can choose to affix either the Bristle Brush or Delicate Fabric Guide inserts into the channel on the top of the silicone Brush attachment as desired. Note, only one function of the 3-In-1 attachment can be used at a time.
CAUTION: Use extreme care when changing the attachments after the unit has been in use as the steam head will continue to be hot.